Crank power is produced by extension and flexion of the hip and knee joints during steady-state pedaling below 120 rpm. Despite the pedaling cadence exceeding 120 rpm during track cycling, the power production strategy for lower-limb coordination above 120 rpm is unknown. This study aimed to assess the effects of various pedaling cadences on the power production strategy of lower-limb coordination during steady-state pedaling. Twenty trained collegiate cyclists performed a 30-s steady-state pedaling exercise at 50% of maximal anaerobic power under four different conditions with 90-, 120-, 150- and 180-rpm pedaling cadences. Pedal kinetics and limb kinematics were recorded using a pedal force measurement system and motion capture system, respectively. Positive mechanical work of hip extension significantly decreased with increasing pedaling cadence (P < 0.05). In contrast, the positive mechanical work of the knee joint flexion significantly increased with increasing pedaling cadence (P < 0.05). For contribution to the total mechanical work at 150 or above rpm, the knee joint showed > 70% of the total contribution, whereas the hip joint showed < 40%. Additionally, the positive mechanical work of the hip shifted to negative mechanical work under 180-rpm condition. These results indicate that power production strategy during steady-state pedaling at 180 rpm is different from the general pedaling cadence. Therefore, specific training needs to be conducted at an excessive-high pedaling cadence such as 180 rpm to achieve high performance in track cycling.
